What are the dimensions and coverage of the VILO SVP-05 with a length of 3 m?

The official sheet describes the SV(P)-05 as a flat PVC-U panel with a total width of 288 mm, useful width of 250 mm, length of 3 m, and weight of 2.30 kg/m². One panel covers 0.75 m². A standard package contains 10 pieces, or 7.5 m² of useful area. The commercial unit of the specific offer must be confirmed, as the package specification does not automatically mean the sale of a full package.

Can the flat VILO SVP-05 be installed vertically?

Yes, the official manual allows SV(P)-05 to be installed both horizontally and vertically, including as wall or ceiling cladding. The orientation changes the arrangement of the substructure and the finishing details used. For vertical installation, horizontal supports and profiles for this orientation are planned; simply rotating the standard horizontal scheme by 90 degrees is not sufficient.

Which wood decors and SKUs are available for VILO SVP-05 3 m?

LATIVA offers five decors: Oak Balance LT-5700, Polar Oak LT-5800, Copper Oak LT-5801, Golden Oak LT-5802, and Winchester LT-5803. These are separate variants of the flat 3-meter SVP-05. For large areas, it is advisable to compare all packages before installation and distribute them across the facade, rather than risk batch differences being concentrated in one section.

What ventilation gap is needed behind VILO SVP-05?

The instructions require a continuous air path behind the cladding and provide guidelines of about 50 mm from the ground at the bottom zone and about 20 mm free outlet at the top. For horizontally placed panels, a vertical batten is used, and for vertical panels, a suitable cross scheme. The inlet and outlet are protected with perforated profiles without blocking air movement.

Why are the screws on VILO SVP-05 not tightened all the way?

PVC-U changes length with temperature fluctuations, so the panel must slide slightly around the fasteners. The screw is placed in the center of the factory hole, and the head does not press the profile immovably. The official document indicates approximately 0.7 mm change per meter at a 10°C temperature difference. The exact end gaps are chosen based on the length and temperature at installation.

Which profiles are used to finish a facade with SVP-05?

The system includes starter SV 11, ventilation SV 11.5 S or M depending on orientation, external corners SV(P) 12/12.5/12V, finishing SV(P) 14, J-profile SV(P) 15, water drainage SV(P) 16.5, and connecting SV(P) 18 according to the specific detail. Quantities are taken from the lengths of plinths, corners, windows, and joints, not as a fixed percentage of the area.